Máy hàn thiếc tự động Robot FA-1000

Functions required for automatic soldering are sold as separate units.
Lower price point can be realized by purchasing necessary units separately.

Please refer to FA-1000 series Configuration Guide from below.

High performance control unit. 256 soldering conditions can be registered.
• I/O port as standard equipment can be connected with various robots.
• Easy-to-operate multi-language touch panel
• Memory card function and tip temperature output to monitor can be added as options.

About Optional Functions
• Memory Card Reader / Writer
You can save soldering configurations on memory cards. Very useful to copy the data to other FA-1000 Control Units and also to backup.
• 1-5 V Analog Voltage Output
Tip temperature is output by 1-5 V analog voltage. An off-the-shelf data logger would be helpful to monitor temperature control.

• Stepping motor controls feed amount precisely.
• Solder wire diameter can be changed by replacing V-groove unit / Clog-detection unit only.
• Use convenient solder-feeding knob to adjust position of solder feed.

Detect solder clogs immediately.
Prevent solder buckling. (When using FA-1000 FD)

Solder-Finish Sensor
*Solder not included

This tube passes solder from the solder reel holder to the V-groove unit. Select the most suitable tube by robot type and solder diameter.

Compact and easily installed on robots and devices.
Built-in linear guide makes high-precision soldering possible. (Stroke length 10mm)
Easier to replace tips with new improved mechanism. (Tip not included)

• Swappable gearbox can make V-groove.
• Vertical grooved rollers prevent solder slippage.
• Flux gas inside the solder can easily escape by V-grooving processing on the solder, and it is possible to reduce “solder and flux scattering” which causes defects.

Fan to suck up flux during air-blow cleaning is included. Easy to clean and maintain.

To attach Air Blow Tip Cleaner, you need Fixing Plate for Air Blow Tip Cleaner.

FA-1000CLP1 : For small robot (FA-3204)
FA-1000CLP2 : For big robot (FA-3304, FA-3404)

Includes a fan for sucking flux when the air blows.

The up and down strokes of the FA-1000SD (Soldering unit) are air-driven.
Up/Down detection sensor.
Stroke length: 10mm / 4mm

To install to a robot, the Fixing Plate for the Air Blow Tip Cleaner is necessary.

Removes scorching of flux on the tip that cannot be removed by Air-blow cleaner.